How to replace TEN with a dishwasher – 10 steps to success In the category Dishwasher Many people are interested in knowledge and learning about many subjects, this knowledge may be vital at some point in your life, attention enough, and dive into more detail more articles and learn more information about How to replace TEN with a dishwasher – 10 steps to success.
If you do not heat the dishwasher and you are convinced that the heating element that has failed is to blame, you will have to replace it with a new one. Do it yourself or call the master – it’s up to you, we will only provide instructions on the replacement of the CHP in the dishwasher. This will allow you to understand whether you can cope and, in fact, what all the work consists of.
First of all, before you replace you have to prepare a small set of tools that includes:
flat and cross screwdriver;
It’s a shilling.
In addition, you need a new TEN, which you have to buy in advance. Keep in mind that the heating elements are indiscriminate (fixed in the heating unit) and disassembled. If there are no fastening elements on the case, then in your case the first version of execution and will have to replace the entire block. Sometimes it is enough to dismantle the TEN from the heating unit and replace only the heater itself.
The basic process
To make all the technology of replacing the ER in the dishwasher was clear to you, we will provide it in the form of step-by-step instructions. Note that different models of the technique may be slightly different fastenings, but in general the disassembly sequence is about the same.
Repairing the dishwasher
So, all the work consists of the following 10 stages:
Disconnect the dishwasher from the net, disconnect the water hose and drain.
Open the door and remove the trays for the dishes, so that in the future they do not prevent the replacement.
Remove the sprinkler, which is installed at the bottom of the dishwasher. To do this, pull the sprinkler up.
Twist the filter installed under the sprinkler, immediately remove the stainless mesh.
Unscrew the screws that hold the pipe and the heating unit itself.
Turn the dishwasher upside down and provide access to the heating element. If the dishwasher is standing free, you need to remove the back wall, if built – the panel.
Dismantle the pump. To do it is quite simple – you just need to twist it clockwise and pull to the side. Everything is done without much effort. Don’t forget to unplug the sensor, clamp and pipe.
Stick your hand under the body and dismantle the rubber fastener that holds the TEN, as well as the hose.
Carefully remove the non-functioning heater.
Replace the TEN with a new one and assemble the dishwasher in reverse order.
The video below shows how to replace the heating element:
That’s the instruction is to replace the CHP in the dishwasher with their own hands. If you are unsure of your abilities, it is better to use the services of specialists. The masters of the service center will be able to change the heating element quickly and inexpensively.
- How to connect the dishwasher
- How to Clean a Dishwasher
- lg dishwasher error message
- Repair of dishwashers error codes
- The dishwasher does not drain or pour water
- An indicator flashes on the dishwasher
- Bosch dishwasher not draining fix
- How to fix a dishwasher that is not filling with water
- how to clean the dishwasher naturally