Using fuse beads to decorate color grout

Using fuse beads to decorate color grout In the category Decorate with Color Many people are interested in knowledge and learning about many subjects, this knowledge may be vital at some point in your life, attention enough, and dive into more detail more articles and learn more information about Using fuse beads to decorate color grout.

Using fuse beads to decorate color grout – Fuse beads  a tool that is used to refinish many kinds of surfaces using tiny glass beads . Beads are non-toxic and completely safe . Fuse beads – a weapon that promotes beads at high speed against the surface. Friction caused by the beads, remove paint, rust and even fungus . The main purpose of use is to fuse the beads to the surface to give new life. Grout may even be decorated using fuse beads. The article that follows will show you how to use the fuse beads to return your grout back to its original splendor .

Step 1 – Prepare the area

Removal of dirt from the liquid solution is held in a small area , so it should be prepared to not only protect themselves , but also the space . First , put plastic sheeting on any glass surfaces such as a mirror or cabinet . Tape it down . Place a plastic sheet on the floor , tub , sink or other areas where you do not want to use fuse beads. Put the stopper in the drain hole as any . Wipe the surface to ensure that they are completely dry . You can also tape the bottom of the door , if you are present .

Step 2 – Safety

There are some security issues that you need to watch using fuse beads. Wear jeans and a sweater to protect your body from the beads. Wear a mask , hat and eye protection as well as gloves to protect the rest of your body.

Using fuse beads to decorate color grout

Step 3 – Prepare Bead Blaster

Fuse beads uses compressed air as a mean to promote beads. Make sure all valves are closed on concern fuse beads and air compressor. You will have 2 hoses . Connect one of the media reservoir to fuse the beads and the other from the air compressor tank to the media. Select a small plastic bead , as the glass could damage the tiles . Open the can and pour the media beads in it to the line . Once the beads are in the canister , pull the score to seal it and make an airtight canister .

Step 4 – Clean the grout

Set in 30 PSI and then turn the air compressor . To start cleaning the grout , you will need to open the air valve on the nose fuse beads. Aim the stream of beads in a liquid solution . Move the fuse beads slowly around the area. Once the canister is empty , close the valve on the lip and then turn off the air compressor. Sweep the beads into a pile and then suck them with a vacuum. Refill canister with beads . Mix 1 cup of bleach to 1 gallon of water , wipe down the wall with a sponge . Dry wall. Repeat this step as needed until the grout is not bright white . Always finish with cleaning the grout with bleach water .

Leave a Reply

Your email address will not be published.